How to train for TPMS tire pressure monitor sensors? 1. Turn the ignition switch to the OFF position, then press and release the brake pedal. 2. Cycle the ignition switch from the OFF position to the run position three times, ending in the run position. 3. Press and release the brake pedal. 4. Turn the ignition switch to the OFF position. 5. Turn the ignition switch from the OFF position to the RUN position three times, ending in the RUN position. The horn will sound once and the TPMS indicator will flash if the training mode has been entered successfully. If equipped, the message center will display TRAIN LF tire. 6. Place the tire pressure monitor activation tool on the left front sidewall (driver's side) of the tire at the valve stem. Press and release the test button repeatedly on the TPMS tool until the horn beeps. (It may take up to 6 seconds for the tool to activate the sensor. Leave the tool in place for the entire 6 seconds.) The beep indicates that the body control module has recognized the TPMS sensor. 7. Within 2 minutes of the horn confirming the programming of the LF tire, place the TPMS tool on the right sidewall (passenger side) of the front tire at the valve stem and press the test button to activate the sensor. 8. Repeat step 7 for the right rear tire, followed by the left rear tire in that order. The procedure is completed after programming the last tire. When training is complete, the message center (if equipped) will display TIRE TRAINING COMPLETE. Interchange Part Number: TPMS-19, 8C2Z-1A203-A Support Models: 2007-2016 for F-450 F-550 Super Duty, 2007-2014 for Edge, 2006-2016 for Escape, 2008-2016 for Expedition, 2006-2016 for Explorer, 2008-2015 and 2008-2016 for Taurus, 2008-2016 for E-150 E-250 E-350 E-450 Econoline, 2008-2011 for Crown Victoria, 2011-2016 for Transit Connect, 2006-2011 for Mercury Milan Color: White Material: Plastic Package Contents: 1 x Tire Pressure Sensor Note: If the vehicle or the wheels/sensors have been stationary for more than 30 minutes, the sensors will go into "sleep mode" to conserve battery power. They should be awakened by simply moving them or rolling the tires before they communicate with the vehicle. Note: The TPMS training procedure should be performed on one vehicle at a time, in an area free of radio frequency interference—at least 3 feet from other vehicles equipped with TPMS sensors. Note: Vehicles with different front-to-rear tire pressures, such as F-series trucks and E-series vans, require TPMS relearning after tire rotation. If the sensors are not trained, the TPMS warning light will illuminate on the instrument panel. Only the above package content is included; other products are not included. Note: Lighting and different display settings may cause the color of the item in the picture to appear slightly different from the actual item. Measurement allows an error of +/- 1-3 cm.