Description Digital LCD display for easy readings, can display measured data and graphics. Rotary switch control, a key measurement for convenient use. Main chip is the DIP, easy for electronic enthusiasts to DIY or update the main chip. Use 9V battery(not included), can also use DC power(DC 6.8-12V). Automatic shutdown, shutdown current is only about 20nA. Automatically detects NPN and PNP transistors, FET, diodes, dual diode, thyristor, SCR, automatic identification of the transistor pinout. Test NPN and PNP transistor common-emitter current amplification factor, the base-emitter threshold voltage, off the collector - emitter leakage current. Support 2 resistors measurement, show its positive and negative, on-state voltage. Resistance measurement maximum resolution 0.01, can be measured up to 50M. Automatically test the pins of a component and show on the display. Measure FET gate threshold voltage and gate capacitance. For the following 2100 resistor while measuring its inductance measuring range from 0.01mH - 20H. Can be used as signal generator and frequency meter: frequency range from 1Hz-2MHz and can generate 1%-99% PWM(pulse width modulation) signals. Notice: Before measuring capacitance, the capacitor must be discharged, otherwise very likely damage the meter. Specifications: Display: 160x128 LCD Power Supply: 1x9V Battery(not included); DC 6.8-12V Current: . 30mA Resistance Measurement: Max. 50M Resistance Resolution: 0.01 Capacitance Measurement: 25pF-100mF Capacitance Resolution: 1pF DC Voltage Measurement: Up to 50V Screen Size: 3.7x3cm/1.45x1.18in Note:Due to different production batches, there is a slight color difference, which does not affect the use. Colour:Red Material:ABS+electronic components Package Contents: 1 * transistor tester 1 * protective case with yellow protective paper Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.