UNIVERSAL ALARM SELF-COPYING REMOTE CONTROL UNIVERSAL ALARM SELF-COPYING REMOTE CONTROL Universal self-copying remote control for the gate, alarm, etc. It is an ideal solution for people who value security. The remote control supports four control channels and receives on the frequency of 433.92 MHz. The device is universal and self-copying, which means that you can easily and quickly install your new remote control. The remote control supports FIXED CODE! i.e. that drivers with variable code WILL NOT BE SUPPORTED! Specification: Battery INCLUDED Frequency: 433MHz 3 functions: copy codes, clear codes and restore codes 4 channels to be programmed Rugged metal housing Pilot dimensions: 55mm x 30mm x 18mm The kit includes: Remote Pendant User manual Battery COPY INSTRUCTIONS: 1. First use - Before the first use and starting to copy the signals, reset the remote control's memory (delete the factory saved signals). 2. Memory erasure (two different methods of use depending on the factory series) - Use Method No.1. If it does not remove, use Method No. 2. Method 1 - Press and hold the and buttons or the open and closed padlock symbols (depending on the remote control model) for 3 - 8 seconds until signaled by a flashing LED. Method 2 - Press and hold the () and () buttons at the same time. Holding the and buttons, after 1 second the red LED will flash 2 times, right after that, release the button and then press it 3 times while keeping the A button pressed and held. The LED will flash. A deleted memory can be recognized by the blue LED not lit by pressing any button or by one flash of the LED. Continuous flashing of the diode with the button pressed means a saved signal. It happens that the factory remote control already has the memory removed. In this case, go straight to the copying procedure. 3. Signal Copy : a) Press and hold the button on the copied remote control to send the signal to be copied continuously. b) Press and hold the button on the remote that will copy the signal to start receiving the signal. The blue LED flashes once. c) Keeping the buttons on both remotes pressed down, bring the remotes as close as possible to each other and wait for a while (maximum 5 seconds). The correct copying of the signal is signaled by a fast flashing or steady light of the blue diode - This process should be repeated for the remaining buttons. Each button can memorize one signal. - If the remote control has not signaled the copying of the signal, please repeat the operation several times, trying to approach the remote controls from different sides. - Copying is helped by touching the metal parts of both remote controls. - A low battery in the copied remote control may make it impossible or difficult to copy the signal. Condition: New Manufacturer's code: Self-copying remote control Manufacturer: otherCNY Model: UNIVERSAL SELF-COPY REMOTE 433 MHz EAN: 9748431352329