Features:_x000D_ _x000D_ Made from premium material, simple construction, long service life. _x000D_ It can effectively help the generator to adjust the current to the standard level. _x000D_ Brand new and high quality rectifier, stable performance. _x000D_ Adopting original imported diode, with excellent rectification function. _x000D_ Professional manufacturing, exquisite workmanship, high reliability. _x000D_ _x000D_ Specification:_x000D_ Condition: 100% brand new_x000D_ Working temperature: - 40 to +125 (thyristor, rapid thyristor); -40 to +150 (rectifier tube, fast recovery diode, ultra-fast recovery diode)_x000D_ Relative humidity: 85%_x000D_ Altitude: below 1000 meters_x000D_ _x000D_ Requirements and Suggestions for module installation:_x000D_ A) The installation surface of the module shall be smooth without scratches, bumps and sundries;_x000D_ B) When installing the module to the heat sink, gently remove the oxide layer on the surface of the heat sink with fine sandpaper, wipe the surface of the heat sink with anhydrous ethanol, and then evenly apply a thin layer of heat-conducting silica gel on the contact surface of the copper base plate and the heat sink to make the contact good and reduce the thermal resistance;_x000D_ C) When fastening the module on the heat sink surface, use M5 or M6 flat batten and spring washer, and fasten the screw with (5+1)Nm force distance;_x000D_ D) The wiring of the main electrode of the module shall be copper strip with smooth, flat and sufficient contact surface. The contact must be good. The tightening moment of force shall be: if M5 screws are used, the moment of force shall be (3) Nm; if M6 screws are used, the moment of force is (5+1)Nm. if M8 screws are used, the moment of force is (9+1) Nm._x000D_ _x000D_ Package List:_x000D_ 1 * MXY16-15 Rectifier Module_x000D_ 1 * MXG16-15 Rectifier Module_x000D_ _x000D_ Note:_x000D_ 1. The environment should be free from violent vibration and impact, and the environment medium should be free from corrosive metal, damaging the insulation of the magazine and atmosphere._x000D_ 2. When forced air cooling is adopted in the module, the wind speed shall be 6 m/s and the ambient temperature shall be -40 to +40.