PDB: Input voltage range: 9~30V (3~6S LiPo) with TVS protection Current Senor: 220A, 3.3V ADC (INAV scale 150, ArduPilot 66.7A/V) Sense resistor: 100A continuous, 220A peak Battery Voltage divider 1K: 10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot) MCU: STM32F405RGT6, 168MHz , 1MB Flash IMU: ICM42688-P Baro: DPS310 OSD: AT7456E Blackbox: Micro-SD card slot 6x UARTs, 1x Softserial_Tx option(INAV) 10x PWM outputs 2x I2C 3x ADC (VBAT, Current, RSSI) Built in inverter for SBUS input USB Type-C(USB2.0) BEC 5V output: Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed Continuous current: 2 Amps BEC 9V /12V output: Designed for Video mitter, Camera, Gimbal ect. Continuous current: 2 Amps 12V option with Jumper pad for stable 9V/12V output, input voltage should Greater than output voltage +1V BEC Vx output: Designed for Servos Voltage adjustable, 5V Default, 6V or 7.2V options Continuous current: 5 Amps, 6A Peak for stable Vx output, input voltage should Greater than Vx voltage +1V FC Firmware: ArduPilot: MatekF405-Wing (ArduPlane 4.4 or er) INAV: MATEKF405SE (INAV 6.0 or er) BEC 3.3V output: Designed for external 3.3V peripherals Linear Regulator Continuous current: 200mA BEC Vx output: Designed for Servos Voltage adjustable, 5V Default, 6V or 7.2V options Continuous current: 5 Amps, 6A Peak for stable Vx output, input voltage should Greater than Vx voltage +1V Material: composite materials colour: Blue Package Contents: 1 x Flight Controller Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.