Handlebar riser kit For Yamaha MT-07 (2021-) These special handlebar risers for MT-07 fit directly under the handlebar. The higher, closer handlebar position results in a more relaxed ride position and a more direct ride. High-quality components fit perfectly. NOTE: Installing this handlebar riser speedometer requires repositioning. The lengths of the brake and clutch cables are short, so in the kit we've paired you with a brake line extension adapter, and a speedometer relocation bracket Details: - 30mm handlebar risers - 21mm offset (closer to body) - Optimization of the sitting position - CNC milled, glass beads blasted and anodized - Extend hydraulic lines 3 cm Scope of delivery: - Handlebar riser *1 (left and right) - Speedometer repositioning bracket *1 - Brake line extension adapter *1 Model: For Yamaha MT-07 (2021-) Brake line extension adapter: Be careful: some brake fluid (or mineral oil, depending on the system) will escape. Grab it and make sure that no part of the vehicle comes into contact with the fluid. Paint may be damaged! The brake and clutch levers must not be damaged as long as the system is on. finished! If this happens anyway, the brake or clutch system must be replaced Get a complete catharsis. Follow the vehicle manual or visit a specialist repair center. In many cases, it is not necessary to vent the hydraulic system (relief when mounted on a transmitter cylinder). Operate the joystick multiple times (at least 3 minutes long). If system pressure has not been established, tighten the brake lever or The clutch lever is under pressure overnight on the handlebar. The system will then function normally again. In individual cases, it may be necessary to vent the system. If the adapter is used at a different point in the brake system or clutch system, Usually the system needs to be vented. For radial cylinders with bottom outlet Assembly without ventilation becomes difficult. control Check the minimum liquid level in the expansion tank window If necessary, fill according to the vehicle manual. Clean any remaining fluid from the outside of the components and check the connections for leaks. Before riding for the first time, a brake test at walking speed is a must. The job is now done! Periodically check tight fit And the tightness of the components must be guaranteed. should be a component damaged and must be replaced immediately.