MCU: STM32H743VIH6, 480MHz , 1MB RAM, 2MB Flash :42688P Baro: for DPS368 (I2C2) OSD: AT7456E (SPI2) : Micro-SD card socket (SDIO) 7x Uarts (1,2,3,4,6,7,8) with built-in inversion. 13x PWM outputs(including "LED" pad) 2x I2C 1x CAN 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2) 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red) 1x SPI3 breakout USB Type-C(USB2.0) 1x JST-SH1.0_8pin connector (Vbat/G/Curr/Rx8/S1/S2/S3/S4) 1x JST-GH1.25_4pin connector (5V/CAN-H/CAN-L/G) Dual Camera Inputs switch 5V/Vbat filtered power ON/OFF switch for FPV OSD is supported by any spare UART Power Vbat Input: 6-36V (2-8S LiPo) BEC: 5V 2A cont. (Max.3A) 3.3V: Max.200mA No Current Sensor built-in ADC Vbat2 pad supports Max. 69V (voltage divider: 1K:20K) Static power: 200mA 5V with Betaflight, 150mA 5V with FC Firmware (ChiBiOS): MATEKH743 BetaFlight: MATEKH743 INAV: MATEKH743 Color: Blue Material: PCB Package Contents: 1 x H743-SLIM 5 x Silicon grommets to M3 1 x JST-SH1.0_8pin cable, 5cm 1 x JST-SH1.0_8pin connectors 1 x JST-GH-4P to JST-GH-4P cable for CAN port, 20cm Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.