/Automatic Induction:/When people enter the induction within the range of 3 meter (10 ft / 120 )it will on,when people leave;it will light off 15 seconds delay. It will turn on only when it is dark and when people motion is detected. /New High-efficiency White LED Technology:/High efficiency, energy saving, long life, energy saving, environmental protection, explosion proof, cold luminescence.10 LED lights that shine brightly so you dont stumble in the dark. /Simple Installation And Wide Range Of Use:/This motion sensor light is fixed with magnetic strip on one side and 3M tape on the other. No tools or screws are needed.Stick-on anywhere conveniently.Applicable to bedroom, baby room, wardrobe, corridor, basement, garage, stairs, warehouse, roof, door and garage entrance and other places. /Easy Power Supply:/This motion sensor night light is powered by 4PCS AAA batteries (not included).Saving installation and charging time,battery can operation with long service time. It is a PIR sensor automatic product.It can detect the motion of people,and when people enter the induction within the range of 3 meter (10 ft / 120 ),it will light on and when people leave it will light off with 15 seconds delay.It will turn on only when it is dark and when people motion is detected.Its stable to work and safe to operate and energy saving to use.It is usually used in the cabinet,wardrobe and corridor etc. Specifications: SwitchPIR sensor Detecting angle: 120 Degrees Detecting distance: Around 3 Meter Distance Service time: 80000h Light Color: Pure White LED quantity: 10 LED Operating current: 120mA Voltage: 6V 4*AAA batteries(not included) LED Brightness: 0.5W Delay time: 15 seconds Material: Aluminum + ABS Operating temperature:-10-50 One Product Size: 7.4*1.2*0.63 in One Light Weight: 3.53oz(not included battery) Package includes: 3 x 10 LED PIR Sensor Cabinet light 1 x User Manual Cautions: 1.Never install this light in the place which is damp and with high temperature,which may affect the normal working of the light. 2.Never install the light in the strong light in case affecting the sensitivity or disoperation. 3.Install the battery before using.The product does not include batteries. 4.When LED getting dimming please change the battery. 5.Please do not install two lights too close from each other. The lighting may cause the other one does not work. 6.Please kindly check if the batteries have been installed in the correct direction. There is an instruction label to prompt you this information.