Compact BNC attenuator designed for reliable RF signal control Key benefits - Control signal levels and protect equipment: precisely reduce RF power to prevent receiver or measurement overload and to match signal levels between instruments. - Broad compatibility: 50 Ω impedance and BNC male-to-female connectors make it plug-and-play with most lab and field RF gear. - Built for durability and repeatable results: stainless steel construction and a 2 W power rating deliver stable attenuation in routine test and deployment environments. What it does and why it matters - Attenuates signals from DC to 3 GHz, allowing you to work across a wide range of RF applications without swapping hardware. - Offers selectable attenuation from 1 dB up to 40 dB so you can make fine adjustments or large reductions as needed. - Provides measured accuracy for precise work: ±0.5 dB accuracy in the 1–10 dB range and ±1 dB accuracy in the 15–30 dB range, enabling dependable signal management for testing and calibration. Key specifications - Connectors: BNC male to BNC female - Impedance: 50 Ω - Frequency range: DC to 3 GHz - Power rating: 2 W - Material: stainless steel - Attenuation range: 1 dB to 40 dB - Accuracy: ±0.5 dB (1–10 dB), ±1 dB (15–30 dB) Practical use scenarios - Lab testing: Insert between a signal generator and device under test to set precise input levels for characterizing amplifiers, filters, and receivers. - Field measurements and antenna work: Reduce strong signals before a spectrum analyzer or receiver to prevent front-end overload while measuring real-world signals. - Equipment integration and debugging: Balance signal levels between mixed equipment (radios, transceivers, test instruments) during system setup and troubleshooting. Notes for safe use - Rated for 2 W; use within the power rating to avoid damage. - Designed for 50 Ω systems; performance may degrade in mismatched systems. This attenuator provides a durable, accurate, and easy-to-connect solution for routine RF attenuation needs across DC–3 GHz systems.